How to Fit Lights to a Water Blade

How to fit lights to a Water Blade

When fitting lights to a water blade it can be quite fiddly, but if you follow the simple sets below set up will be as east as one, two, three!

Take the blade and bend back the metal supports

Position the LED strip so that the lights face forward.

Then simply bend the metal support back around the light to secure into place.

With regards to the wiring, route the cable over the edge of the blade.

Then simply plug the wiring into the transformer and plug in at the wall.

Did this answer your question? Thanks for the feedback There was a problem submitting your feedback. Please try again later.

Still need help? Contact Us Contact Us